Home » News » Steroid Recipes » How to Make Testosterone Enanthate (Test E) 250mg/ml?

How to Make Testosterone Enanthate (Test E) 250mg/ml?

Here’s a Steroid Powder recipe for making 50ml of 250mg/ml Testosterone Enanthate, you could follow same steps but use Testosterone Cypionate powder. Conversion done by WLSBIO.

First,Clean off area you are workin on with rubbing alchol and a cloth. Then go wash hands with antibacterial soap. Set up all ingredients needed, for this experiment it’ll be the following:

12.5g Testosterone Enanthate “Powder”
7.5ml of Benzyl Benzoate
2.5ml of Benzyl Alcohol
29.5ml of your favourite Oil
20CC Syringe
12CC Syringe
2 18ga needles, 1 25ga Needle
.45 Sterile Whatman Filter
50ml Sterile Vial
50ml Vial
Electric Scale
Rubbing Alchol/Paper Towels
Now that all materials are in place,

take out scale (i like to calibrate it

every use) and put on unsterile

50ml vial on scale and zero out.

Get your weight scale here

I like to melt down the powder to

a liquid to find out exactly how

much displacement it takes up.

Start by Drawing up 15ml of

liquid, make sure there are no

air bubbles and plunger is

exactly in line with 15ml hatch

mark. Now slowly squirt test

enanthate into vial until scale

says 12.5 grams. For me this

is usually exactly 12.7-12.8ml

so 1g has a little more then 1

mL displacement but for little

experiments it’s not gonna

matter, just use 1ml per gram

displacement rule. Also add

the 7.5ml of bb and 2.5ml of

ba.

Now add 27.5ml of the 29.5

ml of oil into the vial to make

total volume of oil/ba/bb/

hormone to be 50 mL. Leave

the 2ml of oil in syringe for

later use.

Here’s what it looks like

unfiltered but mixed up.

Now take out sterile 50ml vial

and wipe stopper with rubbing

alchol. Put 18ga needle and 25ga

needle through stopper, and

attach whatman filter to the

18ga needle stuck in vial.

Now open up 20ml syringe and

attach 18ga needle and draw

up 20ml of unfiltered gear. You

will need to repeat this step

another 2 times, last time only

drawing up 10ml.

Picture of filtering process.
Once you’ve filtered all 50ml and

vial is totally empty, take the last

2ml you had saved and run it

through the filter to get all gear

out of it and only leave plain oil

in the filter. This is what final

product will look like. Notice i

left 25ga pin in, there is more

than 50ml in this picture, i had

10ml left over that i wanted to

refilter from last cycle. Look at

that nice golden color, compared

to the amber EQ i made in last

thread.

Now put vial in oven at 200

degrees F, and bake for 15

minutes. Some repeat this

step more than once but

i never have and not had

a problem. There you go,

save yourself a ton of cash

and MAKE YOUR OWN GEAR!

Comments are closed.