Home » News » Steroid Recipes » How to Make Boldenone Undecylenate (Equipoise) 200mg/ml?

How to Make Boldenone Undecylenate (Equipoise) 200mg/ml?

Here’s a recipe for making 50ml of 200mg/ml EQ (Boldenone Undeclyanate).

First , Clean off area you are workin on with rubbing alchol and a cloth. Then go wash hands with antibacterial soap. Set up all ingredients needed, for this experiment it’ll be the following:

10g Boldenone Undeclynate “Powder”
7.5ml of Benzyl Benzoate
2.5ml of Benzyl Alcohol
32ml of your favourite Oil
20CC Syringe
12CC Syringe
2 18ga needles, 1 25ga Needle
.45 Sterile Whatman Filter
50ml Sterile Vial
50ml Vial
Electric Scale
Rubbing Alchol/Paper Towels
Now that all materials are in place,

take out scale (i like to calibrate it

every use) and put on unsterile

50ml vial on scale and zero out.

Get your weight scale here

Draw up 12ml of Eq using 12ml

syringe, make sure there are no

air bubbles and plunger is exactly

in line with 12ml hatch mark. Now

slowly squirt eq into vial until scale

says 10.0 grams. For me this is

usually exactly 10ml so 1g has 1 mL

displacement. Also add the 7.5ml

of bb and 2.5ml of ba

Now add 30 of the 32ml of oil into

the vial to make total volume of oil

/ba/bb/hormone to be 50 mL.

Leave the 2ml of oil in syringe for

later use. Put rubber stopper into

vial aswell as one of the 18ga needles.

Boil a pot of hot water and then

remove from heat and put vial into

pot for 10 minutes, take out after

5 to shake and put back in.

I have a crimper so i crimp another

seal on the vial but you could also

duct tape it on so that rubber stopper

doesn’t come out when upside down

when you’re drawing oil out of vial.

Here’s what it looks like unfiltered

but mixed up.

Now take out sterile 50ml vial and

wipe stopper with rubbing alchol.

Put 18ga needle and 25ga needle

through stopper, and attach

whatman filter to the 18ga needle

stuck in vial.

Once you’ve filtered all 50ml and

vial is totally empty, take the last

2ml you had saved and run it

through the filter to get all gear

out of it and only leave plain oil

in the filter. This is what final

product will look like. Notice i

left 25ga pin in.

Once you’ve filtered all 50ml

and vial is totally empty, take

the last 2ml you had saved and

run it through the filter to get

all gear out of it and only leave

plain oil in the filter. This is what

final product will look like. Notice

i left 25ga pin in.

Now put vial in oven at 200

degrees F, and bake for 15

minutes. Some repeat this

step more than once but i

never have and not had a

problem. There you go,

save yourself a ton of

cash and MAKE YOUR

OWN GEAR!

Comments are closed.